Page 1
1.110-071.0 l for X XXX X XXX X XX X XXX X XX For the Landa Dealer nearest you, consult our web page at WARNING: www.landa.com This product and accessories may contain a chemical known to the State of California to cause cancer and birth defects or other reproductive harm.
KIT INSTRUCTIONS which came with the kit. It contains replacement parts numbers needed for ordering future parts. NOTE: The manual part number is located on the lower right corner of the front cover. Landa PGHW Operator’s Manual 8.916-485.0 - Y...
When ordering parts, please specify model and serial number. Use only identical replacement parts. This machine is to be used only by trained opera- tors. Landa PGHW Operator’s Manual 8.916-485.0 - Y...
10. Use No. 1 or No. 2 heating oil (ASTM D306) only. NEVER use gasoline in your fuel oil tank. Gasoline is more combustible than fuel oil and could result in a serious explosion. NEVER use crankcase or Landa PGHW Operator’s Manual 8.916-485.0 - Y...
Page 7
Do not direct discharge pass through the pump. stream at people or animals, or RISK OF INJECTION OR SEVERE INJURY severe injury or death will result. TO PERSONS. KEEP CLEAR OF NOZZLE. Landa PGHW Operator’s Manual 8.916-485.0 - Y...
Page 8
If diesel is used, add a soot remover to every tankful. WARNING WARNING: Do not spray machines or any people, animals or electrical parts. DO NOT SPRAY MACHINE OR ANY PEOPLE, ANIMALS OR ELECTRICAL PARTS. Landa PGHW Operator’s Manual 8.916-485.0 - Y...
Local purchase of battery will be the responsibility of the owner. Automotive type 12 Volt Group 24 battery is Red + Positive recommended for placement within the weather Terminal resistant box. Follow safety and installation instructions furnished with the battery. Landa PGHW Operator’s Manual 8.916-485.0 - Y...
Nozzle nozzle. Trigger To apply detergent, place detergent pick-up tube Variable Pressure Control Handle into a container of detergent and turn the detergent valve counterclockwise. Landa PGHW Operator’s Manual 8.916-485.0 - Y...
If you run your pressure washer for 3-5 minutes without cavitation and low pressure. pressing the trigger on the spray gun, circulating water in the pump can reach high temperatures. When the Landa PGHW Operator’s Manual 8.916-485.0 - Y...
100°F. trigger on spray gun and siphon water for one minute. STEP 4: Squeeze trigger on spray STEP 5: Remove water supply gun to relieve remaining pressure. hose. Landa PGHW Operator’s Manual 8.916-485.0 - Y...
12. Check to see that engine is properly lubricated. It is advisable, periodically, to visually inspect the burner. Check air inlet to make sure it is not clogged or blocked. Wipe off any oil spills and keep equipment clean and dry. Landa PGHW Operator’s Manual 8.916-485.0 - Y...
Page 15
In alkaline water areas, lime deposits can accumulate The area around the Landa washer should be kept rapidly inside the heating coil. This growth is increased clean and free of combustible materials, gasoline and by the extreme heat build up in the coil.
Page 16
Check with your dealer before making local site fuel pressure adjustments. Landa PGHW Operator’s Manual 8.916-485.0 - Y...
NOTE: If a flue is installed, have a professional serviceman adjust your burner for a #1 or #2 smoke spot on the Bacharach scale. Landa PGHW Operator’s Manual 8.916-485.0 - Y...
Test transformer for proper arc between contacts. Faulty burner transformer Replace as needed. (continued on next Disconnected or short in electrical All wire contacts should be clean and tight. No page) wiring breaks in wire Landa PGHW Operator’s Manual 8.916-485.0 - Y...
Page 19
Fuel Pressure is too high for clean Reduce fuel pressure PSI/Increase air band set for burn (fuel PSI above 140 and below cleaner without max water heat loss 200) and smokes when burner is off Landa PGHW Operator’s Manual 8.916-485.0 - Y...
Page 20
Check and replace if necessary. WATER Cracked piston Check and replace if necessary. DRIPPING FROM UNDER PUMP Lower water supply pressure. Do not run with Pump protector spray gun closed longer than 2 minutes Landa PGHW Operator’s Manual 8.916-485.0 - Y...
Page 21
BURNER MOTOR Defective control switch Replace switch. WILL NOT RUN Loose wire Check and replace or tighten wiring. Defective burner motor Replace motor. RELIEF VALVE Relief valve defective Replace or repair. LEAKS WATER Landa PGHW Operator’s Manual 8.916-485.0 - Y...
(Non-foaming) Change After first 50 hours, then every 500 hours or annually SAE 10W-40 Replace High Pressure Nozzle Every 6 months Replace Quick Connects Annually Clean Water Screen/Filter Weekly Replace HP Hose Annually Landa PGHW Operator’s Manual 8.916-485.0 - Y...
Page 23
Check pump oil level before first use of your new Power Washer. Change pump oil after first 50 hours and every year or 500 hours thereafter. Use SAE 10W-40 non-foaming oil. Estimated Operating Estimated Operating Date Oil Changed Date Oil Changed Hours Since Last Oil Hours Since Last Oil Month/Day/Year Month/Day/Year Change Change Landa PGHW Operator’s Manual 8.916-485.0 - Y...
Page 27
BOLT, 3/8-16 X 2-1/4", GR8.2 SERATED FLANGE B 8.718-781.0 SCREW, 40MM, PAN HD 9.802-781.0 NUT, 3/8" FLANGE WHIZ LOC NC 8.706-600.0 BATTERY, M-100, LARGE 8.916-471.0 ASSY, POWER PLATFORM PGHW5-3500 8.932-992.0 MOUNT, RUBBER VIBRATION. 3/8" 70 DURO 8.920-485.0 WLMT, SKID, PGHW Landa PGHW Operator’s Manual 8.916-485.0 - Y...
Page 28
(4-3000, 4-4000) 8.712-355.0 NOZZLE, SAQCMEG 2505, GREEN (5-3000) 8.712-359.0 NOZZLE, SAQCMEG, 2502.5 GREEN (5-3500) 8.712-380.0 NOZZLE SAQC MEG, 2509 (8-3000) 8.712-348.0 NOZZLE, SAQCMEG, 4004 WHITE (4-3000, 4-4000) 8.712-356.0 NOZZLE, SAQCMEG 4005 WHITE (5-3000) Landa PGHW Operator’s Manual 8.916-485.0 - Y...
Page 29
FUEL NOZZLE, 2.50 X 80 A WITH 100PSI CHECK VALVE NOT SHOWN, PGHW5 8.756-409.0 CONNECTOR, LEVER NUT, 2-WIRES NOT SHOWN 8.756-410.0 CONNECTOR, LEVER NUT, 3-WIRES NOT SHOWN 8.756-411.0 CONNECTOR, LEVER NUT, 5-WIRES NOT SHOWN Landa PGHW Operator’s Manual 8.916-485.0 - Y...
Page 47
If “spike” pressure exceeds the 500 psi limit, remove the adjusting knob (Item 18) and re-adjust (lower) the nuts (Items 15) on the stem (Item 8). Re-attach the adjusting knob (Item 18), then repeat step #6. Landa PGHW Operator’s Manual 8.916-485.0 - Y...