Table of Contents
Advertisement
3. Preparing and Installation
3.1 Site Selection
The hydraulic ATV lift is designed only for indoor use. Application in a room with explosion hazard is not permitted.
Setting in a wet place, a car wash bay for instance, is also not recommended. Make sure to check the desired location for
possible obstructions such as a low ceiling, overhead lines, adequate working area, access ways, exits, etc.
3.2 Surface Condition
The lift should be installed on level ground with a concrete surface free from as many defects as possible to prevent unit
from tipping or rocking. Only use on a level concrete surface with a recommended minimum thickness of 4". DO NOT
install on an asphalt type surface.
Failure in accomplish the foundation requirement may cause the lift instability or personal injury.
Installing on asphalt, soft clay floor or near the expansion gap is prohibited.
3.3 Necessary Tools
Scissors, Screw Driver, Rubber Hammer, Adjustable Spanner Wrench, (Ext.) Snap Ring Pliers and Hex Key Set.
Forklift & Soft Sling Straps also recommended.
3.4 Personal Protective Equipment
Always wear proper protective equipment like proper clothing, shoes, gloves & safety glasses, etc.
3.5 Set-Up & Installation
1. Unpacking
a. Carefully open crate and remove any loose parts from top of lift structure.
b. Using a forklift (recommended) carefully remove lift from crate and place in the desired location (Fig.1).
Ensure to check product and packing list to make certain all required parts are included and in good
condition.
Fig.1
9
Oct. 2018
A-2200IEH-XR
Advertisement
Table of Contents
