Advertisement
Quick Links
Models: TTP-A-2-93 / TTP-A-3 / TTP-A-4-93 / TTP-A-4HW-93 / TTP-A-6 / TTP-A-6HW
Note: 2-inch horizontal steel pipes shown in the pictures above are not included. Purchase locally or from us.
TTP-A-2-93
TTP-A-3
TTP-A-4-93
TTP-A-4HW-93
TTP-A-6
TTP-A-6HW
support@tamaracksolar.com
Installation Manual
2 Module Top of Pole Mount
3 Module Top of Pole Mount
4 Module Top of Pole Mount
4 Module Top of Pole Mount, High Wind
6 Module Top of Pole Mount
6 Module Top of Pole Mount, High Wind
1-800-819-7236 Ext 556
REV5-93
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Tamarack Solar TTP-A Series
Summary of Contents for Tamarack Solar TTP-A Series
- Page 1 Installation Manual Models: TTP-A-2-93 / TTP-A-3 / TTP-A-4-93 / TTP-A-4HW-93 / TTP-A-6 / TTP-A-6HW Note: 2-inch horizontal steel pipes shown in the pictures above are not included. Purchase locally or from us. TTP-A-2-93 2 Module Top of Pole Mount TTP-A-3 3 Module Top of Pole Mount TTP-A-4-93 4 Module Top of Pole Mount...
- Page 2 Pole Mount Installation Manual TTP-A Series Scan the QR Code below to see an animated video of the assembly of this mount Or go to: https://instructions.online/?id=1424-cb%20no%20hoist Use these torque settings when assembling your TTP-A mount. If you are using anti-seize compound on bolts, reduce torque by 15%.
- Page 3 Pole Mount Installation Manual TTP-A Series Disclaimer This manual describes proper installation procedures and provides necessary standards required for product reliability. Warranty details are available on our website. www.tamaracksolar.com All installers must thoroughly read this manual and have a clear understanding of the installation procedures prior to installation.
- Page 4 Pole Mount Installation Manual TTP-A Series TTP-A Series Pole Mount - COMPONENTS Mount Model>>> TTP-A-2 TTP-A-3 TTP-A-4 TTP-A-4HW TTP-A-6 TTP-A-6HW Category & Part # Part Description Item # Vertical Mounting Pole Top Cover Front Half of Pole Cap with 2.5-inch Holes...
- Page 5 Pole Mount Installation Manual TTP-A Series Foundation Hole and Pole Guidelines • The suggestions below are recommendations only. It is the installer’s responsibility to validate foundation parameters prior to installation; a local geotechnical report may be required to assess soil conditions. We...
- Page 6 Pole Mount Installation Manual TTP-A Series TTP‐A-2 For Array Ground Clearance of 3 Feet Foundation Hole Depth, Height of Pole Above Ground and Total Pole Length for Ground Clearance of 3 Feet at Lowest Part of the Array & Exposure Catgory B For Various Soil Class and Foundation Hole Diameter. Vertical Pipe is 4-inch Schedule 40.
- Page 7 Pole Mount Installation Manual TTP-A Series TTP‐A-3 For Array Ground Clearance of 3 Feet Foundation Hole Depth, Height of Pole Above Ground and Total Pole Length for Ground Clearance of 3 Feet at Lowest Part of the Array & Exposure Catgory B For Various Soil Class and Foundation Hole Diameter. Vertical Pipe is 4-inch Schedule 40.
- Page 8 Pole Mount Installation Manual TTP-A Series TTP‐A-4 and TTP‐A-4HW for Array Ground Clearance of 3 Feet Foundation Hole Depth, Height of Pole Above Ground and Total Pole Length for Ground Clearance of 3 Feet at Lowest Part of the Array & Exposure Catgory B For Various Soil Class and Foundation Hole Diameter. Vertical Pipe is 6-inch Schedule 40 (Highlighted sections require 6-inch Schedule 80 Pipe) Soil Type →...
- Page 9 Pole Mount Installation Manual TTP-A Series TTP‐A-6 and TTP‐A-6HW for Array Ground Clearance of 3 Feet Foundation Hole Depth, Height of Pole Above Ground and Total Pole Length for Ground Clearance of 3 Feet at lowest part of the array & Exposure Catgory B For Various Soil Class and Foundation Hole Diameter. Vertical Pipe is 6-inch Schedule 40 (Highlighted sections require 6-inch Schedule 80 Pipe) Soil Type →...
- Page 10 Pole Mount Installation Manual TTP-A Series Step One - Pole Cap Assembly • Place Vertical Mounting Pole Top Cover/Cap on top of 4 or 6 inch vertical mounting pole. • Put Pole Cap Support Bolt through the two top holes in rear half of the Pole Cap, install Pole Cap Flange Nut and tighten firmly.
- Page 11 Pole Mount Installation Manual TTP-A Series Step Three - Assemble Adjuster Arm • Attach Adjuster Arm to Adjuster Pipe with U-Bolt and the two flange nuts. Hand tighten, for now. • Using Adjuster Arm move H-Frame assembly to approximately horizontal position. Set this position...
- Page 12 Pole Mount Installation Manual TTP-A Series Step Five - Module Mounting Rail Assembly • Two and four module mounts: use 93-inch Module Mounting 3.1 Rails provided. Go to Step 6. • Three and six module mounts: ship with 132-inch rails made of two 66-inch Module Mounting 3.1 Rails.
- Page 13 Pole Mount Installation Manual TTP-A Series • Place one Module Mounting 3.1 Rail on two of the Pipe Mounts with U-Bolt installed on the Rail Support Pipes. Center rail in north/south direction so it extends past both Support Pipes the same distance. Make sure Pipe Mount with U-Bolt slips into both the mounting features on the bottom of the rails (see drawing at right).
- Page 14 Pole Mount Installation Manual TTP-A Series • Start module installation at bottom of first column. Measure up the rail by 1/2 the distance calculated in #2 above. Place one 5050 Module Mounting Clamp on each Module Mounting 3.1 Rails at this distance.
- Page 15 Pole Mount Installation Manual TTP-A Series Certified Module List for UL2703 Listing Program Manufacturer Model Aleo P18/P19/S18/S19/S59/S79. AU Optronics PM Series modules with 30, 35, 40, and 45 mm frames aaSMbbyyC/zz-xxx Where “aa” can be CH or A; "bb" can be 60, 66, or 72; “yy” can be blank, 10 or Astronergy 12;...
- Page 16 Pole Mount Installation Manual TTP-A Series Certified Module List for UL2703 Listing Program Manufacturer Model D6M and D6P 30 mm frames EVPVxxxA, Where “A” can be blank or KPanasonic modules with 35 and 40 mm frames VBHNxxxYYzzA Where “YY” can be Panasonic either KA, RA, SA or ZA; “zz” can be either 01, 02, 03, 04, 06, 06B, 11, 11B, 15, 15B, 16, 16B, 17, or 18; and “A” can be blank, E, G, or N Peimar 40 mm frames SbxxxYzz Where “b”...
Need help?
Do you have a question about the TTP-A Series and is the answer not in the manual?
Questions and answers