Filter - L.B. White I17 Owner's Manual And Instructions

FIG. 11
WATER HOSE
3. Repeat steps 2 and 3 until water runs clean.
4. Inspect the cones and venturi tube to make sure
these areas are clean.
5. Return the heater to its original hanging position.
6. Shake the heater vigorously to clear water off of the
combustion cones to allow proper ignition of gas at
the inner cone.
7. Relight the heater to dry out the cones and the
venturi tube.
B. FILTER (accessory)
A. During continued use:
- Remove filter and shake off dust.
- Do not squeeze or tap filter while filter is installed
on heater. Doing so will cause dust to be blown
into venturi tube or combustion cones.
B. After continued use or before building repopulation:
- Remove filter and shake off dust.
- Use compressed air or water (standard faucet
pressure) to clean it.
- Do not use high pressure water, air, or a washing
machine. Filter material damage may occur.
- If water is used, squeeze out excess water from
filterbefore installation.
- Let filter dry before lighting heater.
13