HOW TO OPTIMIZE THE DOS-MODE
PLUG AND PLAY
Plug & Play DDC1/2B Feature
This monitor is equipped with VESA DDC1/2B capabilities according to the VESA DDC STANDARD. It allows the monitor
to inform the host system its identity and, depending on the level of DDC used, communicate additional information about its
display capabilities. The communication channel is defined in two levels, DDC1 and DDC2B.
The DDC1 is a unidirectional data channel from the display to the host that continuously transmits EDID information. The
DDC2B is a bidirectional data channel based on the I
C protocol. The host can request EDID information over the DDC2B
THIS MONITO WILL APPEAR TO BE NON-FUNCTIONAL IF THERE IS NO VIDEO INPUT SIGNAL. IN
ORDER FOR THIS MONITOR OT OPERATE PROPERLY, THERE MUST BE A VIDEO INPUT SIGNAL.
This monitor meets the Green monitor standards as set by the Video Electronics Standards Association (VESA) and/or the
United States Environmental Protection Agency (EPA) and the Swedish Confederation Employees (NUTEK). This feature is
designed to conserve electrical energy by reducing power consumption when there is no video-input signal present. When
there is no video input signal this monitor, following a time-out period, will automatically switch to an OFF mode. This
reduces the monitor's internal power supply consumption. After the video input signal is restored, full power is restored and
the display is automatically redrawn. The appearance is similar to a "Screen Saver" feature except the display is completely
off. The display is restored by pressing a key on the keyboard, or clicking the mouse.
USING RIGHT POWER CORD
The accessory power cord for the Northern American region is the wallet plug with NEMA 5*15 style and is UL listed and
CSA labeled. The voltage rating for the power cord shall be 125 volts AC.