Important Notes - Ledj Slimline Q5 Series User Manual

Optional IR remote functions:
Button functions:
01 - Sets the LEDs into power on or off modes
02 - Runs the built-in programs, use the '+' and '-'
buttons to go through the programs
03 - Sets the LEDs to flash on and off, use the '+'
and '-' buttons to change the flash frequency
04 - Sets the run speed, use the '+' and '-' buttons
to change the desired speed (note: only
available in
the colour change or colour fade modes)
05 - Sets the LEDs into DMX mode
06 - Sets the LEDs into sound active mode
07 - Sets the LEDs into slave mode
08 - Sets the DMX address for the LEDs
09 - Sets the LEDs colour, then use the '+' and '-'
buttons to change the brightness
DMX address examples:
To set the DMX address "245";
• Press the "S" button, the red LEDs will come on,
you can now start to set the DMX address
• Now press the "2" button, the green LEDs will
come on, this means the first digit has been
set at 2
• N ow press the "4" button, the blue LEDs will
come on, this means the second digit has been
set at 4
• N ow press the "5" button, and the white/amber
LEDs will come on, the third digit 5 has been set.
The full DMX address setting has been changed
• Now press the "DMX MODE" button to save
the new address into the memory

Important notes:

• Set the DMX address on each fixture before plugging into the DMX controller
• The IR remote cannot be used when the fixture(s) are being controlled with a DMX controller
• The maximum IR transmitter distance is 10m - Please make sure that you have the IR remote
aimed directly at the front panel of each fixture to be programmed
• If you do not press the "DMX MODE" button after you have changed the DMX address when you
power down the fixture it will lose the address you have set
www.prolight.co.uk
Operating instructions
01
02
BLACKOUT
R
09
AMBER/WHITE SELECT PROG
06
AW
S PR
DMX MODE SOUND ACTIVE
05
D SA
1 2 3
4 5 6 0
7 8 9
To set the DMX address "002";
• Press the "S" button, the red LEDs will come on,
you can now start to set the DMX address
• Now press the "0" button, the green LEDs will
come on, this means the first digit has been
set at 0
• N ow press the "0" button, the blue LEDs will
come on, this means the second digit has been
set at 0
• Now press the "2" button, and the white/amber
LEDs will come on, the third digit 5 has been set.
The full DMX address setting has been changed
• N ow press the "DMX MODE" button to save
the new address into memory
Slimline Q5 Series User Manual
09
03
DIMMING
G B
04
FLASH SPEED
FL SP 07
08
SLAVE SET ADDR
SL S
+
_
Optional
IR remote
Order code:
LEDJ90C
8