Ledj Slimline Q5 Series User Manual page 6

RGBW colour mix mode:
In this mode you can set the fixture to any colour and any brightness.
To access the colour mix mode, press the "MENU" button on the rear of the unit to show
with 3 digits after on the LED display. Press the "ENTER" button to confirm.
r
The represents red,
The 3 digits after are the brightness setting from
For example:
r G b U
If you set , , , all to zero, your unit will have no LEDs lit up (blackout).
r000 r255
If you set to
Press the "ENTER" button to confirm the setting and move to the next colour.
To exit out of any of the above options, press the "MENU" button.
RGBA colour mix mode:
In this mode you can set the fixture to any colour and any brightness.
To access the colour mix mode, press the "MENU" button on the rear of the unit to show
with 3 digits after on the LED display. Press the "ENTER" button to confirm.
r
The represents red,
The 3 digits after are the brightness setting from
For example:
r G b A
If you set , , , all to zero, your unit will have no LEDs lit up (blackout).
r000 r255
If you set to
Press the "ENTER" button to confirm the setting and move to the next colour.
To exit out of any of the above options, press the "MENU" button.
Built-in program mode:
To access built-in program mode press "MENU" until the display shows
Press the "ENTER" button and use the "UP" and "DOWN" buttons to select between
Press the "ENTER" button and use the "UP" and "DOWN" buttons to select the speed between
Sp-9
~ . Press the "ENTER" button and use the "UP" and "DOWN" buttons to select the flash speed
F--0 F--9
between ~
To exit out of any of the above options, press the "MENU" button.
Slave mode:
Press the "MENU" button on the rear of the unit to show
"ENTER" button to confirm the setting. The unit will now run in sequence with the master unit.
To exit out of any of the above options, press the "MENU" button.
Please ensure that all slave units are set to the same DMX channel mode as the master unit.
www.prolight.co.uk
G b U
= green, = blue,
G b o
and , and
G b A
= green, = blue,
G b A
and , and
.
F--0
= white and = strobe.
000 255
~ , or the strobe speed from
to zero, your unit will show only red LEDs.
F--0
= amber and = strobe.
000 255
~ , or the strobe speed from
to zero, your unit will show only red LEDs.
SLAU
on the LED display and press the
Slimline Q5 Series User Manual
Operating instructions
r---
0
r---
0
Pr--
on the LED display.
Pr00
~
9
~ .
9
~ .
Pr20
.
SP-0
6