Bushnell Stableview 18-1035 Quick Reference Manual page 12

During fine mode operation, the LED will alternately flash in orange and green.
Briefly pressing the power button again will switch operation back to normal mode, and the LED will
return to a steady green light.
Stabilization Lever
Setting the stabilization lever back to the HOLD position turns the stabilization feature off, and the
LED turns orange again, indicating Standby mode.
Set the stabilization lever as you wish.
Standby mode conserves battery power.
When finished, turn the stabilization lever to the HOLD position and press the Power button to turn off.
If you leave your Bushnell StableView binoculars in either Standby or Stabilization mode for a few
minutes without using them, the stabilization lever will return to the HOLD position, and the
binoculars will shut off automatically.
Stabilization lever position
HOLD
ACTIVE
HOLD
6
power button operation
Hold down
Press briefly,
then release
for several seconds in
standby mode
Hold down
Equipment status
ON (Standby)
Switches between
fine and normal
modes
OFF
LED status
Lit/flashing orange
Alternately flashing
green/orange (fine)
or steady green
(normal)
OFF