Wet System - Husqvarna K770 Workshop Manual

4. With a plastic hammer, push or hit the axle down
until the spacer touches the inner ring of the bearing.
5. Use the assembly support (2) to make the bearing
housing level. Put the support on the first bearing.
6. Put the axle with the bearing in the bearing housing
with the spacer down.
7. With a plastic hammer, push or hit the axle down.
60 - Repair and servicing

6.15 Wet system

6.15.1 Function
Each side of the blade guard has a spray nozzle. The
water hits a section of the cutting blade and the
centrifugal force moves it out to the edge. The spray
nozzles are available with many different hole diameters
made for different types of machines and uses. Find the
correct nozzle in the spare parts list.
2
6.15.2 To disassemble the wet system
1. Remove the screws that hold the spray nozzle.
2. Remove the filter with a wood screw.
1
651 - 001 - 27.06.2018