Flywheel - Husqvarna K770 Workshop Manual

6.2.10 To assemble the ignition unit
1. Align the magnet on the flywheel with the ignition
unit.
2. Put the air clearance gauge (.01 in/0.3 mm) against
Servicing tools overview on page
the magnets. See
10 .
3. Put the new unit in position. Push it against the
gauge as you tighten the screws. Tighten them with
a torque of 10–12 Nm.

6.3 Flywheel

6.3.1 To remove the flywheel
A special tool from Husqvarna must be used to
disassemble and assemble the flywheel. See
tools overview on page 11 . The tool can be used on
most flywheels on Husqvarna power cutters.
1. Remove the starter and lower air duct.
2. Loosen the springs and put the start hooks in their
outer positions.
651 - 001 - 27.06.2018
3. Put a 13 mm socket on the centre screw of the
flywheel.
4. Attach the flywheel puller over the socket. Use the
correct screw, supplied with the tool.
Servicing
5. Lock the flywheel from turning with the handle of the
special tool. Remove the nut and washer.
Repair and servicing - 27