Table of Contents
Advertisement
UPSI-1208DPx
F General Data
F1 Assembly and installation advice
Installation and operation of this device is only allowed to be executed by a qualified
electrician! The application has to be separated from any power during the mounting process.
Wires have to be connected safely and must not have contact with sharp edges. Pay attention
to correct polarity! Before commissioning, check all the connections for correctness!
F2 Convection and installation position
For these DIN rail versions, vertical mounting on a horizontal rail (DIN rails according to EN 60715) is recom-
mended in order to achieve the best possible convection of the UPS. Another mounting position is possible,
but operation up to the respective highest ambient temperature can not be guaranteed.
Make sure that no ventilation holes are covered by other, neighboring components and devices.
The following distances to neighboring devices are recommended:
Left / right:
20 mm
Top / bottom: 50 mm
The devices comply with the IP protection class 20.
Revision 1-5
19
Advertisement
Table of Contents
