Unpacking And Assembly; Installation - Whirlpool 8LIECHK-SSF-WL User Manual

UNPACKING AND ASSEMBLY

Remove the dispenser from packaging:
TO OPEN:
TOP
1. Lay the box containing the unit on its side.
2. Open bottom flaps of the cardboard box.
3. Stand cooler upright, with box flaps unfolded.
4. Pull box straight up.
5. Unpack the drip tray and insert it into the dispenser.
6. Keep original packing for the duration of warranty.

INSTALLATION

WARNING
Excessive Weight Hazard
Use two or more people to move and install bottles.
Failure to do so can result in back or other injury.
Note: Do NOT plug in the power cord until told to do so.
1. Place the dispenser on a hard and level surface in a cool,
shaded location, free of kitchen grease and oil, near a
grounded wall outlet.
2. Position dispenser so that the back is at least 4 inches from
the wall, and there are at least 4 inches of clearance on
both sides.
3. Level the water cooler as shown below to prevent vibration.
There are two leveling feet at the back of the water cooler.
Please adjust them one at a time until the water cooler sits
levelly and does not rock. Failure to level the water cooler
can cause vibrational noise when the compressor runs.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-594-4755 for assistance.
TOP
TOP
Use two or more people to move and install the
water cooler and the bottles.
Failure to do so can result in back or other injury.
Model # 8LIECHK-SSF-WL: Page 6
WARNING
Excessive Weight Hazard
2 levelling feet