Whirlpool 8LIECHK-SSF-WL User Manual page 9

Hot, room & cold temperature water cooler
Table of Contents

Advertisement

NOTE: Fit all round bottles. When using a 5 gallon rectangular bottle, slide it into place as shown in
the illustration below.
• If the probe tube A and B are not sealed(see previous page), the pump will run a few minutes
and the night lights will flash. To correct, open the door, re-attach the probe, and close the door.
• If the lights continue to flash, your bottle may be empty or there may be an issue with the water
tube lines. Call 1-855-594-4755 for assistance.
3. Turn the switches at the back of the dispenser to ON.
• The red switch controls the hot water. If you do not want hot water, leave this switched OFF.
• The blue switch controls the cold water. If you do not want cold water, leave this switched OFF.
• The yellow switch controls the LED night lights. Turn it ON or OFF as desired.
• For the unit to operate properly, the probe head must seal on the bottle and the door must be
fully closed.
It will take less than 3 minutes
pump to run on and off.
• If water fill stops before reservoirs are full, please open and close the door to reset door acti-
vated switch.
• Each time you dispense water from the taps, the pump will turn on to refill the tanks.
Dispensing Cold Water
Note: After setup, it will take up to 1 hour to get the water to its coldest temperature. During this
time, the compressor may run continuously as the refrigeration system builds the Ice Bank as noted
in the "Product Features" section.
1. Position the container you wish to fill with water securely below the cold-water tap.
• The right triangle below the cold water control indicates the location of the cold water tap
(See the "Parts & Features" section on page 5).
• The circular shapes in the drip plate help align the flow of water. This unit dispenses water
quickly. To avoid splashes, hold the cup as close to the tap as possible.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-594-4755 for assistance.
to fill reservoirs with water. During this time, it is normal for the
Model # 8LIECHK-SSF-WL: Page 9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents