Schedule Tab Programming - Lennox ComfortSense 7000 Series Programming And Application Manual

Schedule Tab Programming

If backlight is not on continuous, press the screen
anywhere to turn on the backlight. Press the SCHEDULE
tab along the top of the screen. The display changes to pro-
gramming mode (figure 4) and shows the current settings.
EVENTS DAILY 2 OR 4 The thermostat may be pro-
grammed for two or four (default) events per day. The
names for the events are: WAKE, LEAVE, RETURN, and
SLEEP. The selected time for an event to occur is based
on when you want the event to begin. Four events (de-
fault) are common for working households. To change to
two events per day, see page 9. When set for two events
per day, the display would appear as: WAKE (or SLEEP)
PERIOD BEGINS".
WAKE PERIOD BEGINS
5:OOAM
Figure 4. Schedule Screen
506230−01 05/09
Programming may be performed in groups of days or indi-
vidual days, as follows:
A MON TO SUN − allows every day to be set the same.
B MON TO FRI − (weekday programming) and
SAT TO SUN (weekend programming).
C MONDAY through SUNDAY allows individual days of
the week to be programmed separately.
NOTE − After using one of the groups of days described
above, the program allows you to subsequently change
individual days to suit your needs.
To get to the different groupings of days, press EDIT, then
press NEXT repeatedly to scroll to the desired grouping.
Programming Complexity
The programming process for groups of days or individual
days is the same, except in the amount of times required to
go through the process.
Full Week The least complex program is the full week
MON TO SUN" program, wherein the events for every day
of the week are the same. This requires one time through
the event programming process.
Work Week Next in complexity to the full week program
is the work week program wherein the events are set for a
typical work week (MON TO FRI) and different events are
set for the weekend (SAT TO SUN). This requires two
times through the events.
Day by Day Most complex because this requires going
through the programming process 7 times.
Page 6