D Touch For Auto Bed Leveling (Optical) - Geeetech A30T User Manual

button to start printing.
Note:
A30T has 3 extruders, which equipped 3 "Filament" detectors. Therefore, it would be
displayed as green only if 3 "Filament" detectors are detected at the same time in the
printing information interface.

10.33D Touch for auto bed leveling (Optical)

This printer supports auto bed leveling. Refer to the link below to know how to install the 3d
touch sensor.
Youtube:
https://www.youtube.com/watch?v=_RtsZDbR2po&t=66s
Visit our official forum:
http://www.geeetech.com/forum/
Shenzhen Getech Technology Co.,Ltd
（Picture 10-8）
56