Geeetech A30T User Manual page 50

2) After importing the .Gco file, you can set the height of start and end layer, and the discharge
change percentage of extruders according to actual needs. You can adjust by dragging the
slider or entering a value. See picture (9-3).
3) In addition, you can click "Add" to add multiple configuration boxes to adjust the extruder
discharge change ratio at different starting and ending heights. See picture (9-4).
4) See picture (9-5), Adjust discharge change ratio of each extruder in a range of heights as
needed, click the E0, E1, E2 button in the "Preview" window in the upper right corner to
Shenzhen Getech Technology Co.,Ltd
（Picture 9-2）
（Picture 9-3） （Picture 9-4）
50