Geeetech A30T User Manual page 11

3) Connect the E0, E1, and E2 extruder motor wires .See picture (5-8).
Then the extruder wires and the extruder motor wires are fixed into the small hole on the
backside of the screw with the Cable tie to avoid the wires harness touching the model during
printing. In addition, the position the harness fixed needs to be reserved the length of the Z-axis
at the maximum height. See picture (5-9).
Shenzhen Getech Technology Co.,Ltd
（Picture 5-7）
（Picture 5-8）
11