10-2.Function Settings By Using Remote Controller - Fujitsu ARYG12LHTBP Design & Technical Manual

10-2. Function settings by using remote controller
Some function settings can be changed on the remote controller. After confirming the setting proce-
dure and the content of each function setting, select appropriate functions for your installation envi-
ronment.
¢ Setting procedure by using wired remote controller
The function number and the associated setting value are displayed on the LCD of the remote con-
troller. Follow the instructions written in the local setup procedure supplied with the remote controller,
and select appropriate setting according to the installation environment.
Before connecting the power supply of the indoor unit, reconfirm following items:
• Piping air tight test and vacuuming have been performed firmly.
• There is no wiring mistake.
1. Connect the power supply.
2. Touch the "Function Setting" on the "Maintenance" screen. The "Function Setting" screen is dis-
played. Then touch the "Address" on the "Function Setting" screen.
3. "Address" screen is displayed. Select the address of the indoor unit whose function number is
to be set by touching ▲ or ▼. When setting at all the indoor units, touch "All".
NOTE: Perform this step only when the remote controller address setting is required. Otherwise,
skip this step.
4. Touch the "Function No." on the "Function Setting" screen.
5. "Function No." screen is displayed. Set the function number "11" by touching ▲ or ▼. When the
"OK" is touched, the display returns to the "Function Setting" screen.
10-2. Function settings by using remote controller
Function Setting
Address [002–01]
Function No. [00]
Setting No. [00]
Back Setting
Address
All
002–01
Cancel OK
Function Setting
Address [002–01]
Function No. [00]
Setting No. [00]
Back Setting
Function No.
11
Cancel OK
- 63 -
10. Function settings