Fujitsu ARYG12LHTBP Design & Technical Manual page 135

6. Press the ENTER switch button (SW3) and fix it.
7. To return to "Operating status display (Normal operation)", press the EXIT switch button (SW4).
In case of missing how many times you pressed the SELECT and ENTER switch buttons:
1. To return to "Operation status display (Normal operation)", press the EXIT switch button once.
2. Restart from the beginning of setting procedure.
NOTE: In case of missing how many times you pressed the SELECT and ENTER switch buttons,
you must redo the setting procedure. Return to "Operation status display (Normal opera-
tion)" by pressing the EXIT switch button once, and restart from the beginning of the setting
procedure.
¢ Peak cut mode
1. Press the MODE switch button (SW1) for 3 seconds or more to switch to "Local setting mode".
2. After confirming the LED lamp of POWER/MODE blinks 9 times, press the ENTER switch but-
ton (SW3).
3. Press the SELECT switch button (SW2), and adjust the LED lamp as shown below. Then the
LED lamp indicates the current setting.
13-2. Local setting procedure
MODE 1: Low
MODE 2: Lower
LED lamps
(1) (2) (3) (4)
SW1 SW2 SW3
Switch buttons
PUMP
POWER
LOW NOISE
DOWN
ERROR
MODE
(L1) (L2)
Blinks
)
(9 times
Sign " ": Lights off
PEAK CUT
E
MOD
- 129 -
PEAK CUT
(L4) (L5) (L6)
(5)
SW4 SW5
PEAK CUT
(L3) (L4) (L5) (L6)
LOW NOISE
(L2) (L3)
Blink
13. Function settings (AOYG45LBTA and AOYG54LBTA)