10-2.Function Settings By Using Remote Controller - Fujitsu AUU9RLF Design & Technical Manual

10-2. Function settings by using remote controller
Some function settings can be changed on the remote controller. After confirming the setting proce-
dure and the content of each function setting, select appropriate functions for your installation envi-
ronment.
¢ Setting procedure by using wired remote controller
The function number and the associated setting value are displayed on the LCD of the remote con-
troller. Follow the instructions written in the local setup procedure supplied with the remote controller,
and select appropriate setting according to the installation environment.
Before turning on the power of the indoor unit, reconfirm following items:
• Piping air tight test and vacuuming have been performed firmly.
• There is no wiring mistake.
1. Turn on the power.
2. Press the SET TEMP. buttons (
onds to enter the function setting mode.
3. Press the SET BACK button to select the indoor unit number when you set the remote con-
troller address setting.
4. Press the set time buttons to select the function number.
5. Press the SET TEMP. buttons (
setting value selection.
6. Press the TIMER SET button to confirm the setting. Press the TIMER SET button for a few sec-
onds until the setting value stops flashing. If the setting value display changes or if "- -" is dis-
played when the flashing stops, the setting value has not been set correctly. (An invalid setting
value may have been selected for the indoor unit.)
10-2. Function settings by using remote controller
) ( ) and FAN button simultaneously for more than 5 sec-
SU MO TU WE TH FR SA
SU MO TU WE TH FR SA
SET BACK
Unit number of indoor unit
SU MO TU WE TH FR SA
Function number
) ( ) to select the setting value. The display flashes during
SU MO TU WE TH FR SA
- 34 -
Setting value
10. Function settings