Precautions During Mounting - JVC BLUEscent DLA-VS47NV Instructions Manual

Precautions during Mounting

Securing (mounting) the projector
Securing the projector (directly mount)
For directly mounting projectors to a stand for motion or non-motion systems, remove the four feet from the base of the
projector and use the inner six mounting screw holes (see pictures below).
CAUTION
Use ONLY the fixing screws specified for mounting the projector. Using any screws other than those specified can
cause damage and malfunction to the projector. NEVER insert the four outer feet into the inner screw holes, as the
length of the screws are to long and will cause damage to the unit. If the mounting instructions are not followed, issues
or failure can occur.
Non-Motion Applications
Outer 4 screw holes can be used
Screw Specifications
M5 (screw pitch 0.8)
0
The screw length into the body of the projector must
0
not exceed 15 to 25mm.
The length of the screw will be determined by the
0
depth of the projector mounting plate.
Example - If the plate is 5mm thick a screw between
20 to 30mm must be used.
Torque 1.5Nm to 2.0Nm.
0
Do not use 2 adjacent locations (A+B, B+C, C+D, D
0
+E) only.
Front
A
B
C
D
Rear
When this unit is to be mounted to a fixed position for
0
use, install it horizontally.
Make sure to secure the main unit to prevent accidents
0
such as during an earthquake.
Motion Applications
Inner 6 Screw holes must be used
Screw Specifications
M5 (screw pitch 0.8)
0
The screw length into the body of the projector must
0
not exceed 17 to 25mm.
The length of the screw will be determined by the
0
depth of the projector mounting plate.
Example - If the plate is 5mm thick a screw between
22 to 30mm must be used.
Torque 1.5Nm to 2.0Nm.
0
Front
Rear
19