Edge Blending; Installation Style - JVC BLUEscent DLA-VS47NV Instructions Manual

Edge Blending

Corrects the seam between the images during projection by multiple projectors.
* This function is disabled when "Picture Mode" is set to "Dynamic".
Edge Blending
For setting the function to On or Off.
Setting
Off
On
Guide
For setting the guideline display (start point: green; end point: red).
Setting
Off
On
Position Select
For setting the compensation position.
Setting
Top
Bottom
Left
Right
Start/End
For setting the start and end points of the compensation position selected in "Position Select".
Setting range: 0 to 255 (left/right), 0 to 135 (up/down)
0
Black Level
For adjusting the black level.
Setting range: 0 to 50
0

Installation Style

For setting to "Front", "Ceiling Mount (F)", "Rear", or "Ceiling Mount (R)" according to the installation status of the
projector.
"Front" or "Ceiling Mount (F)" is set when projector is installed in the front with respect to the screen.
0
"Rear" or "Ceiling Mount (R)" is set when projector is installed in the rear with respect to the screen.
0
* When using the projector with the lens shifted in the vertical direction, the amount of distortion at the upper and lower
ends may be different and the curvature distortion may not be fully corrected.
Disables the Edge Blending function.
Enables the Edge Blending function.
Hides the guideline.
Displays the guideline.
For setting the start and end points using the Start/End item.
Description
Description
Description
43