Hardware Reset In The Event Of Unit Failure - RADEMACHER Troll Basic 5602 Instruction Manual

i

19. Hardware Reset in the event of Unit Failure

We recommend resetting the hardware if a unit fails.
i
1.
Carefully pull the operating unit off the installation housing.
2.
Wait approx. 5 seconds and then carefully reinsert the operating
unit into the installation housing.
3.
Subsequently check that the Troll Basic 5602 is functioning
correctly.
4.
If the Troll Basic 5602 is still not reacting, carry out a software
reset (see page 50) and test the Troll Basic 5602 with the
factory settings.
All settings remain unaltered when the hardware is
reset. The internal clock will stop, the same as when
there is power failure.
EN
49