17.1 Automatic dusk function;
The automatic dusk function is switched on by setting or
changing the sensitivity.
Configure the brightness at the level (dusk) which the blinds
should be closed.
Set current brightness (dusk) as set limit and switch on the
automatic dusk function.
1.
+
2.
The current brightness is now set as the set limit and the
automatic dusk function is activated.
If this value is exceeded, the roller shutters will roll down to the
lower end point.
3.
46
configuration of sensitivity
1 sec.
Simultaneously briefly press the buttons.
Observe the dusk LED:
OFF
Automatic dusk function OFF
ON
Automatic dusk function ON
Flashing...
◆ ...if the set limit is exceeded.
◆ ...if the current brightness value is
within the measured range while
configuring the set limit.
EN