Connecting A Tubular Motor - RADEMACHER Troll Basic 5602 Instruction Manual

i

9.1 Connecting a tubular motor

1.
Ensure the mains are current-free and check whether the
inlet leads are current-free.
2.
Securely lay the connecting cables right into the flush-mounted
box.
3.
Remove the insulation on all leads down to 6 mm in length and
connect them according to the following connection diagram.
4.
After the electrical connection, the installation of the Troll Basic
5602 into the flush-mounted box is carried out, see page 29.
Connecting the white set cord (SET) from RADEMACHER
tubular motors
The white set cord (SET) from RADEMACHER tubular motors
must be connected to the neutral terminal [ N ] to ensure
trouble-free operation of the tubular motor.
EN
27