Inventory - Grizzly G0726 Owner's Manual

Inventory

The toolbox and other small parts are inside
the base of the column. You must remove
the coolant pump access panel and the
coolant pump from the rear of the column
to access these items.
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Description: (Figure 2)
A. Front Way Cover ......................................... 1
B. Rear Way Cover ......................................... 1
C. Drawbar
⁄ "-11 x 11" ................................... 1
5
8
D. Fine Downfeed Handle ............................... 1
E. Ball Handles (X-Axis) ................................. 2
F.
Ball Handle (Y-Axis) ................................... 1
G. Auto-Downfeed Direction Pin ..................... 1
H. Toolbox ....................................................... 1
I. Ball Handle Handles ................................... 3
J. Bottle for Oil ............................................... 1
K. Z-Axis Crank ............................................... 1
L. Hex Wrench Set 1.5-10mm ........................ 1
M. Coarse Downfeed Handle .......................... 1
N. Screwdrivers Slotted #2, Phillips #2 .. 1 Each
O. Wrench 18 x 21mm Closed-Ends ............... 1
P. Wrench 17 x 19mm Closed-Ends ............... 1
Q. Splash Pan ................................................. 1
R. Coolant Return Hose w/Clamp ................... 1
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Model G0726 (Mfg. Since 7/11)
A
C
E
J
L
Qty
Figure 2. Small item inventory.
D
F
G
H
I
K
M
O
N
Q
R
B
P
-15-