Minuteman ER26 Service Manual page 39

8.2 Entering Service Mode with a Stuck Actuator
To enter into service mode with the brush
•With the machine turned off, unplug the P2 connector on the controller •With the machine turned off, unplug the P2 connector on the controller
•Turn the machine on and press the service mode switch up to 30 •Turn the machine on and press the service mode switch up to 30
seconds, and then release. seconds, and then release.
•Plug the P2 connector back in with the machine still turned on. •Plug the P2 connector back in with the machine still turned on.
•Press the lower side of the service mode switch to lower the brush deck. •Press the lower side of the service mode switch to lower the brush deck.
actuator stuck in the up position
Page 39