Minuteman ER26 Service Manual page 16

4.3 ES2832,CP2832, and Phoenix 34
It is now available to change the brush pressure settings in It is now available to change the brush pressure settings in
the field, when changing brush decks on current production the field, when changing brush decks on current production
models of the Easy Scrub 28 and 32. No other modifications models of the Easy Scrub 28 and 32. No other modifications
will be required. will be required.
Changing the brush pressure settings will only be required, Changing the brush pressure settings will only be required,
when changing the cylindrical over to the disk deck or disk when changing the cylindrical over to the disk deck or disk
over to the cylindrical decks. Changing the size only over to the cylindrical decks. Changing the size only
(Example: Changing the 28 disk to 32 disk) will not require (Example: Changing the 28 disk to 32 disk) will not require
changing the settings. changing the settings.
The orange/violet wire from the controller has been added to The orange/violet wire from the controller has been added to
change settings. change settings.
Connecting the orange/violet wire to the terminal block puts it Connecting the orange/violet wire to the terminal block puts it
in the low-pressure mode for cylindrical decks. in the low-pressure mode for cylindrical decks.
Disconnecting the orange/violet from the terminal block puts Disconnecting the orange/violet from the terminal block puts
the brush pressure in the high-pressure mode for disk decks. the brush pressure in the high-pressure mode for disk decks.
Instructions: Instructions:
1. Remove the switch panel, by removing the four screws. 1. Remove the switch panel, by removing the four screws.
2. Locate the terminal block. See Photograph. 2. Locate the terminal block. See Photograph.
Page 16