Minuteman ER26 Service Manual page 20

5. Table of Error Codes (SC280000 Models)
2C00 LOW BATTERY ERROR
2C01 LOW BATTERY ERROR2
2C02 SOFT BATTERY LOCKOUT OCCURRED
2C03 SOFT BATTERY LOCKOUT 2 OCCURRED
2F01 TILLER DISPLACED ERROR
3A00 BAD SETTINGS
7000 STARTUP WITH PUSH SELECTED
7001 PUSH ACTIVATED IN DRIVE MODE
7500 TILLER COMMS TIMEOUT
7600 SOFT BRUSH MOTOR DISCONNECTED ERROR
7601 SOFT BRUSH CURRENT FOLDBACK
7602 7602 SOFT BRUSH CURRENT FOLDBACK2 SOFT BRUSH CURRENT FOLDBACK2
7603 SOFT BRUSH CURRENT FOLDBACK3
7604 SOFT BRUSH INHIBIT
7605 BRUSH STARTUP OVERCURRENT DETECTION
7700 SOFT VACUUM MOTOR DISCONNECTED ERROR Check Vacuum Motor wiring and connectors
7701 SOFT VACUUM CURRENT FOLDBACK
7702 SOFT VACUUM CURRENT FOLDBACK2
7703 SOFT VACUUM CURRENT FOLDBACK3
7800 TRACTION MOTOR FAULT-1
7801 TRACTION MOTOR OVER CURRENT ERROR
7802 TRACTION MOTOR IN FOLDBACK STATE
7803 MOTOR LINE VOLTAGES INSTABILITY TIMEOUT
7804 TRACTION MOTOR IN DRIVE BOOST
7880 TRACTION SPEED INPUT OUT OF RANGE
7900 EMERGENCY STOP ERROR
7901 SOFT BELLY BUTTON ACTIVATED
8000 SERVICE MODE
9000 BRUSHES NOT FITTED
Battery Charge to low. Recharge battery.
Battery Charge to low. Recharge battery.
Battery Charge to low. Recharge battery.
Battery Charge to low. Recharge battery.
Throttle displaced on Power-up. Release throttle and then re-engage throttle.
Illegal program parameter settings.
Freewheel Input signal detected at startup. Disconnect Freewheel input.
Freewheel Input signal activated while driving. Disconnect Freewheel input.
Problem with LCD Module or wiring. Repair or replace as necessary.
Check Brush Motor wiring and connectors
Too much Brush Pressure/Current. Check for jammed Brushes or Deck or Brush motor short.
Too much Brush Pressure/Current. Check for jammed Brushes or Deck or Brush motor short. Too much Brush Pressure/Current. Check for jammed Brushes or Deck or Brush motor short.
Too much Brush Pressure/Current. Check for jammed Brushes or Deck or Brush motor short.
Brush Inhibit signal is active.
Possible Brush motor problem or shorted brush circuit wiring.
Too much Vac motor current. Check for shorted Vac motor or wiring.
Too much Vac motor current. Check for shorted Vac motor or wiring.
Too much Vac motor current. Check for shorted Vac motor or wiring.
Check Traction Motor wiring and connectors
Too much Traction motor current. Check for shorted Traction motor or wiring.
Traction Motor was overloaded for too long, Control limiting current to protect motor.
Possible Traction Motor or loose wiring problem.
Traction Motor under heavy load or Current Limit / Fold back parameters set too low.
Check Throttle Potentiometer and wiring.
Emergency Stop function activated.
Safety Bar switch is activated. (ES and CP models only)
Service Timer limits have been reached.
Check Brush Deck to make sure Brushes are fitted properly.
Page 20