Sharp AH-X127E Service Manual page 36

AH-X127E
AU-X127E
AY-X127E
AE-X127E
6. After closing the open panel, open the horizontal
adjustment louver and pull out the bottom of the front
panel toward you.
Lifting the front panel, strongly pull the top toward you.
Making the front panel parallel to the main body, strongly
pull it toward you for removal.
To install the front panel, place the bottom of the front
panel under the open horizontal adjustment louver, and
press in the front panel, parallel to the cabinet. When
pressing it in, take care to prevent the top of the blow-out
port of the drain pan from being caught by the front panel.
7. Remove the unit-to-unit wiring from the terminal board.
(Loosen the screw with the screwdriver, and pull out the
wiring.)
8. Remove one fastening screw from the control box cover.
9. Remove the control box cover.
Holding its bottom, pull and disengage the upper hook
toward the bottom.
10. Remove the ground wire. (One screw)
Note: During reassembly, take care for the direction
of the lead wire.
11. Remove the protect cover for the dew.
Note: During reassembly, verify that the dew on the
pipe is recovered to the drain pan.
36