Table of Contents
Advertisement
HANGING INSTRUCTIONS
1. Assemble according to the illustration and tighten all
eyebolts securely.
FIG. 2
EYEBOLT
NUT
FLAT WASHER
CAGE NUT
2. Be sure heater is securely fastened and is hanging
level. (Check crosswise and lengthwise.)
3. See Fig. 3 for typical indoor installation. In any animal
confinement building, consideration must be given to
making sure the heater is located away from the
livestock so that livestock cannot knock the heater,
tear it loose from its mounting, or damage the heater
or its gas supply line in any way. Make sure you
observe and obey minimum clearance distances to
combustible materials as stated in the specification
section of this owner's manual and on the heater
itself.
SEDIMENT TRAP ASSEMBLY
(Optional Accessory)
Assemble the tee, nipples and cap together and tighten
securely.
The sediment trap assembly must always be
mounted in a vertical position.
compound that is resistant to both L.P. gas and natural gas
is used in making all connections. Check a a ll c c onnections f f or
gas l l eaks u u sing a a pproved g g as l l eak d d etectors.
10
NOTE: REGULATORS SHOULD ALWAYS BE MOUNTED OUTDOORS. IF
CHAIN
CASE TOP
Make sure pipe thread
FIG. 3
CIRCUMSTANCES FORCE INSTALLING THE REGULATOR INDOORS,
THE REGULATOR'S VENT MUST BE VENTED OUTDOORS USING VENT
LINE NO SMALLER THAN VENT OPENING.
VENT OF REGULATOR MUST
POINT DOWN AND REGULATOR
MUST BE VENTED OUTDOORS
OPTIONAL INDOOR
REGULATOR
MOUNTING LOCATION
GAS HOSE
THERMOSTAT
CORD
YOKE
.3 M
30.5CM
THERMOSTAT
FIG. 4
NIPPLE
TO GAS CONTROL
VALVE INLET
MANUAL SHUT-OFF VALVE
CAN BE INSTALLED BEFORE
THE REGULATOR, UNDER
THE EAVE OF THE BUILDING,
OR AFTER THE REGULATOR
INSIDE THE BUILDING.
BLACK PIPE
THROUGH WALL
WALL OUTLET
HEATER
POWER CORD
SEDIMENT
.3 M
TRAP
30.5CM
HOSE ADAPTER
TEE
NIPPLE
CAP
VENT LINE
Advertisement
Table of Contents
