Table of Contents
Advertisement
Söllnerstr. 9
(SD1=XXh,SD1=YYh,CPU=ZZZ,FC=UUh)
ErrCode 20: Unknown protocol at PPIMultimaster-Mode. (FC=XXh,Länge=YYY)
ErrCode 21: Unknown baud-rate at PPIMultimaster-Mode. (Baudrate=XXh)
After that additional hints are displayed.
SMS:
SMS: Switches Processing OFF / Only Receive / Only Send / Receive and Send.
Attention: before setting ON check configuration, after activating the device will go into the MPI-BUS and
tries to connect to the defined PLC. Receive of SMS only with TELESERVICE-GSM Receive of DTMF only with
with TELESERVICE GSM
TS: local station-address (should not be used twice in the MPI/Profibus!)
PLC: from this station-address the Flagword and Data-block is accessed for communication
MW: communication-flagword (the first byte is the command, the second is the state). Use even operand-
addresses.
DB: communication-data-block.
Provider 1/2/3/4: Configure the SMS-Provider to use, including type, phone-number and char-code.
Internet/Mail
9.3.4.3.4 „Import parameter"
With this button you could import the parameter from an ASCII-file. This file is compatible to the original
file-format.
9.3.4.3.5 „Export parameter"
With this button you could export the parameter to an ASCII-file which has the same file-format as the
original.
MPI-USB user manual
92637 Weiden
info@traeger.de
+49 (0)961 48 23 0 0
81 / 93
2022/01/21 01:28
Advertisement
Table of Contents
