Table of Contents
Advertisement
Söllnerstr. 9
92637 Weiden
info@traeger.de
+49 (0)961 48 23 0 0
4. Choose the desired MPI cable and click „OK" to go on.
5. If the connection is established the chosen cable is shown in the section state and on the left side you
can see the status connected.
6. It also displays, the PLC-VCOM the IP address for the module and the IP address of the computer which
is connected to the module.
If you have any promlems with the use of PLC-VCOM software, go to the chapter
PLC – VCOM
and look
there for operating instructions.
6.3 Programming software to use with direct
access
After you have adjusted and connected the PLC-VCOM or the programming adapter to the COM-port on
your computer, you will be able to connect with your programming software to the PLC and work with it.
How you have to adjust your programming software is described in the following points:
6.3.1 PG2000 für S7 (V5.10)
1. Start the PG 2000 software by using the desktop link or by using the application entry in the start menu.
2. Choose from "View" ⇒ "S7-300/400" In the menu "Options" click "Interfaces"..
MPI-USB user manual
19 / 93
2022/01/21 01:28
Advertisement
Table of Contents
