Traeger 9352-USB User Manual page 74

Söllnerstr. 9 92637 Weiden info@traeger.de +49 (0)961 48 23 0 0
In this dialog you could configure the modem-related setup.
The Init-String is composed out of several commands to the modem:
AT ⇒ start command
&F ⇒ use factory settings
E0 ⇒ Echo off
L1 ⇒ loudness of speaker is low
M1 ⇒ speaker is on at connection
Q0 ⇒ output of the return values
V1 ⇒ return values plain text
&C1 ⇒ DCD shows status of the carriersound
S0=1 ⇒ automatic connection after 1 ring
The Hang-Up-String is composed of 2 elements:
+++ ⇒ Change to command-mode
AT ⇒ start command
H ⇒ Hand-Up connection
There are 2 possible calling technics:
MFV tone, the telphone-number is transfer by several frequencies
IWV pulse, the telephone-number is transfered with the count of several pulses on the line
When you must a pre-call to establish a call outside your company, you could define it at Amtskennzahl.
When the modem should wait for a free line, so you should set the corresponding checkbox.
At number of retries you could configure the number of retries for a connection before the call is stopped.
When using a retry you could choose the seconds which the application should wait between calls.
Serial parameter
MPI-USB user manual 74 / 93 2022/01/21 01:28