Table of Contents
Advertisement
Söllnerstr. 9
8.5.2 Index "Modem":
In this dialog you could configure the modem related setup.
Modem Settings:
The initialization string consists of several commands to the modem together:
AT ⇒ start command
&F ⇒ use factory settings
E0 ⇒ echo off
L1 ⇒ volume of speaker is low
Initialization
M1 ⇒ speaker is on at connection
Q0 ⇒ output of the return values
V1 ⇒ return values plain text
&C1 DCD ⇒ shows status of the carrier sound
S0=1 ⇒ automatic connection after 1 ring
The deselection text consists of 2 parts:
+++ ⇒ Switch to command mode
Hang up
AT ⇒ start command
H ⇒ Hang up connection
Location:
Dialing
Access code
To access an outside
line, first dial
Call Preferences:
Wait for dial tone before
dialing
MPI-USB user manual
92637 Weiden
info@traeger.de
The phone system uses There are two possible call techniques:
MFV tone, the telephone number is transfered by several frequencies
IWV pulse, the telephone number is transfered with the amount of several
pulses on the line
If you need a prefix before your number to establish a call outside, you must
enter the prefix here e.g. 0.
In case the modem should wait for a free line, you should set the
corresponding checkbox.
+49 (0)961 48 23 0 0
55 / 93
2022/01/21 01:28
Advertisement
Table of Contents
