Table of Contents
Advertisement
15.1.2 Initial setting
DIP switch and rotary switch setting
Remove the cover from the controller and perform the DIP switch and rotary switch setting.
Rotary switches DIP switch
Cover
1. DIP switch setting
The functions of this controller are set according to the DIP switch settings.
Each switch is set to the OFF and ON positions as shown below.
The functions of this controller are selected by DIP switch.
The DIP switches are set to OFF when the controller is shipped from the factory.
DIP switch
1
2
3
4
5
6
7
8
2. Rotary switch setting
The address of this controller is set by the rotary switch.
When this controller is shipped from the factory, the address is set to "000".
Setting range: 000, 201-250
(Always set the address to "000" when K-transmission converter is being controlled.)
OFF
ON
OFF: User operation mode
OFF: Master system controller
OFF: No K-transmission converter installed
OFF: Operation prohibit setting valid
Reserved for future use ( Leave this switch set to OFF )
External input changeover
The range of a controller which the operation is prohibited
OFF: Both of the system controller and the local remote controller
ONJ: Only the local remote controller
100digit 10digit
1digit
1 Remove the cover screw.
Note:
When this controller is shipped from the factory, the screw is
contained in the same package.
2 Insert a standard screwdriver into the slot and twist it to
remove the cover from the upper case.
ON
ON: Initial setting mode
ON: Slave system controller
ON: K-transmission converter installed
ON: Operation prohibit setting invalid
( Example: Address setting: 000 )
183
Advertisement
Table of Contents
