Mitsubishi Electric Lossnay LGH-100RX3-CAN Technical Manual page 120

4.4.3 Operation with 2 Remote controllers
Characteristics
• Lossnay can be operated from two remote locations.
• Lossnay conditions can be checked from two remote Lossnay remote controller
locations.
• The remote controller gives priority to the last touch.
System Example
Transmission
cable extension
is 500 m or less
PVC cable
ø0.65 to 1.2 or
strand wire
2
0.3 mm to 1.25 mm
Remote controller
PZ-41SLB-E
Operation Method
(1) When there are 2 remote controllers, "2 CONTROLLERS" will display on the LCD readout's upper region.
(2) The operation is the same with each remote controller. In this case, the Lossnay gives operating priority to the last button
push.
Lossnay Lossnay
Power supply
2
.
Transmission
cable extension
is 500 m or less
PVC cable
ø0.65 to 1.2 or
strand wire
2 2
0.3 mm to 1.25 mm
Remote Remote
controller controller
Close-up of
display region
Remote controller
PZ-41SLB-E
Lossnay up to 15 units,
or 7 units for LGH-200RX type
(Be sure to turn on the power for the
Power supply
second and following Lossnay units.)
Lossnay Lossnay
Power supply
Remote controller
PZ-41SLB-E
Lossnay
.
Remote Remote
controller controller
PZ-41SLB-E PZ-41SLB-E
Lossnay
2CONTROLLERS
AUTO
BY-PASS HEAT EX.
Note
• Use only up to 2 remote controller
(Operation will not go normally if 3
remote controller switches are con-
nected.)
Lossnay up to 15 units,
or 7 units for LGH-200RX type
(Be sure to turn on the power for the
second and following Lossnay units.)
Power supply
Lossnay
Power supply Power supply
117