Mitsubishi Electric Lossnay LGH-100RX3-CAN Technical Manual page 131

5.1 External Control Operating Mode Selection
There are four modes when operating using signals from external equipment.
1. ON/OFF interlock ( the last trigger from either external signal or remote control switch has priority )
2. ON interlock
3. OFF interlock
4. External priority ON/OFF interlock
Operating Signal
Mode When external signal is level signal.
External signal
ON/OFF
inter-
Remote controller
lock
[ON/OFF] button pressed
Operating
condition
External signal
ON
inter-
Remote controller
lock
[ON/OFF] button pressed
Operating
condition
External signal
OFF
inter-
Remote controller
lock
[ON/OFF] button pressed
Operating
condition
External
External signal
priority
ON/OFF
Remote controller
[ON/OFF] button pressed
inter-
lock
Operating
condition
Setting Method
When PZ-41SLB-E is used . . . . . . Set with the remote controller. (Refer to page 174)
When PZ-41SLB-E is Not used . . . Set with the dip switch. (Refer to page 168)
128
Operating
Stopped
Operating
Stopped
Operating
Stopped
Operating
Stopped
When external signal is pulse signal.
( Optional setting )
External signal
Remote controller
[ON/OFF] button pressed
Operating Operating
condition Stopped
External signal
Remote controller
[ON/OFF] button pressed
Operating Operating
condition Stopped
External signal
Remote controller
[ON/OFF] button pressed
Operating Operating
condition Stopped
This mode does not exist.