Table of Contents
Advertisement
Chapter 4: AMI BIOS
with a remote host server. The options are dependent on the avail-
able COM ports.
Terminal Type
Use this feature to select the target terminal emulation type for Con-
sole Redirection. Select VT100 to use the ASCII character set. Select
VT100+ to add color and function key support. Select ANSI to use the
extended ASCII character set. Select VT-UTF8 to use UTF8 encoding
to map Unicode characters into one or more bytes. The options are
VT100, VT100+, VT-UTF8, and ANSI.
Bits per second
This item sets the transmission speed for a serial port used in Con-
sole Redirection. Make sure that the same speed is used in both host
computer and the client computer. A lower transmission speed may
be required for long and busy lines. The options are 9600, 19200,
57600, and 115200 (bits per second).
Flow Control
Use this item to set the flow control for Console Redirection to pre-
vent data loss caused by buffer overflow. Send a "Stop" signal to stop
data sending when the receiving buffer is full. Send a "Start" signal
to start data sending when the receiving buffer is empty. The options
are None, Hardware RTS/CTS, and Software Xon/Xoff.
The settings for each of these features is displayed:
Data Bits, Parity, Stop Bits
4-45
Advertisement
Table of Contents
