Partner SP-1000-B Service Manual page 3

Pos terminal

Table of Contents

This publication, including all photographs, illustrations and software, is protected under international

reproduced without written consent of the author.

Disclaimer

The information in this document is subject to change without notice. The manufacturer makes no representa-

tions or warranties with respect to the contents hereof and specifically disclaims any implied warranties of

merchantability or fitness for any particular purpose. The manufacturer reserves the right to revise this publi-

cation and to make changes from time to time in the content hereof without obligation of the manufacturer to

notify any person of such revision or changes.

Trademark recognition

All product names used in this manual are the properties of their respective owners and are acknowledged.

Federal Communications Commission (FCC)

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer-

ence in a residential installation. This equipment generates, uses, and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of

the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment onto an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Shielded interconnect cables and a shielded AC power cable must be employed with this equipment to ensure

compliance with the pertinent RF emission limits governing this device. Changes or modifications not ex-

pressly approved by the system's manufacturer could void the user's authority to operate the equipment.

Declaration of conformity

This device complies with part 15 of the FCC rules. Operation is subject to the following conditions:

This device may not cause harmful interference, and

This device must accept any interference received, including interference that may cause undesired operation.

Table of Contents