Toshiba MMC-AP0188HPUL Service Manual page 91

No. Part name
9
Under panel
1. Detachment
1) Perform works of 1 of
2) Remove the support plate.
(24-48 type only) (Ø4 x 10, 1 pc.) The
screw on a front side is removed, and
it detaches it from the square hole on
the back side.
3) The screw on both sides is removed.
(Ø4 x 10, 2 pcs.)
4) The screw on fan side is removed.
18-30 type : (Ø4 x 10, 3 pcs.)
36-48 type : (Ø4 x 10, 4 pcs.)
5) Slide to the air discharge side and
remove the under panel.
NOTE
When you remove forcibly which
may result in the product breaks.
6) When you remove the signal receiving
unit, lap the end of flat head screw
driver with vinyl tape, and forcedly
insert it into the groove at the side
under circle mark on the cover.
2. Attachment
1) Attach the under panel from air
discharge side according to drain pan.
2) Attach the screws as original position.
24-56 type attach the support plate as
original position.
Procedure
8 .
Flat blade screwdriver
(Lap it with vinyl tape.)
Vinyl tape
Insert it into groove at
the side under circle
mark on the cover.
Square hole
Screws
Cover
- 91 -
Remarks
Front side screw
Support plate
Screws
Screws