Table of Contents
Advertisement
7-1. Setup of Selecting Function in Indoor Unit
(Be Sure to Execute Setup by a Wired Remote Controller)
<Procedure> Execute the setup operation while the unit stops.
3
5
6
1
1
SET
CL
Push
,
, and
The firstly displayed unit No. indicates the header indoor unit address in the group control.
In this time, the fan of the selected indoor unit is turned on.
2
UNIT LOUVER
Every pushing
are successively displayed. In this time, the fan of the selected indoor unit only is turned on.
3
Specify the CODE No. (DN) using the setup temperature
4
Select the setup data using the timer time
(When selecting the DN code to "33", change the temperature indication of the unit from "°C"
to "°F" on the remote controller.)
5
SET
Push
button. (OK if display goes on.)
To change the selected indoor unit, return to procedure
To change the CODE No. to be set up, return to procedure
6
TEST
Pushing
button returns the status to normal stop status.
7. APPLIED CONTROL
TEMP.
TIMER SET
TIME
FILTER
RESET
TEST
SET
TEST
buttons simultaneously for 4 seconds or more.
(left side button) button, the indoor unit numbers in the group control
ON / OFF
FAN
MODE
SAVE
VENT
CL
SWING/FIX
UNIT LOUVER
and
and
buttons.
2
.
3
.
- 36 -
4
2
buttons.
Advertisement
Table of Contents
