Epsolar LS1024RPD Instruction Manual page 9

Step 1: Choose Mounting Location
Locate the controller on a vertical surface protected from direct sun, high
temperature. And make sure good ventilation.
Step 2: Check for clearance
Place the controller in the location where it will be mounted. Verify that
there is sufficient room to run wires and that there is sufficient room above
and below the controller for air flow.
150mm(5.9inches)
150mm(5.9inches)
Step 3: Mark Holes
Use a pencil or pen to mark the four (4) mounting hole locations on the
mounting surface.
Step 4: Drill Holes
Remove the controller and drill 4mm holes in the marked locations.
Step 5: Secure Controller
Place the controller on the surface and align the mounting holes with the
drilled holes in step 4.
Secure the controller in place using the mounting screws.
WARNING: Risk of explosion! Never install the
controller in a sealed enclose with flooded batteries! Do
not install in a confined area where battery gassed can
accumulate.
Figure 3-1 Mounting and cooling
5
Warm air
Cool air