Table of Contents
Advertisement
10. Insert the tabs on the
aiming
ring into the
11. Holding the aiming ring closed, insert the screws at
the end of the ring. Tighten -the screws until the
aiming ring
touches the plastic nuts on both the top
and bottom.
0
Da not overtighten.
12. Do not damage the vertical aiming bubble.
13. Plug the electrical connector into the headlamp
socket. Make sure the locking tabs snap onto the
socket.
14. Put the headlamp assembly in position. Make sure
the two guide tabs drop into their holes in the
headlamp support panel.
guide tabs are still in place before tightening the
screws.
15. Tighten the two bottom screws. Make sure the
16.
Insert the top screw and tighten it.
17. Close the headlamp panel.
6-34
Advertisement
Table of Contents
