Table of Contents
Advertisement
6
4. Lift the plastic locking tabs on the electrical
connector and pull the connector from the headlamp
socket.
Note which way the socket is pointing before
you disconnect it. You'll need to install the
new headlamp so the socket points in the same
direction.
5. Set the headlamp assembly on a work surface with
the lens facing you.
6. Remove the Torx@
screws at the end of the
aiming ring. The aiming
ring will swing open like
a gate.
7. Remove the aiming ring. Place it face down on the
work surface with the aim indicator up.
8. Check that the number on the new headlamp
matches the number on the headlamp being replaced.
The letter on the headlamp (U or
L)
must also match.
9. Put the new headlamp in position.
Make sure the socket points in the same direction
as it did with the old headlamp.
6-33
Advertisement
Table of Contents
