How To Add Fluid - Pontiac 1994 Grand Am Owner's Manual

Then, Without Shutting Off the Engine,
Follow These Steps:
1. Pull out the dipstick and wipe it with a
clean rag or paper towel.
2. Push it back in all the way, wait three
seconds and then pull it back out
again.
3.
Check both sides of the dipstick, and
read the lower level. The fluid level
must be in the cross-hatched area.
4. If the fluid level is in the acceptable
range, push the dipstick back in all the
way.
How to Add Fluid
Refer to the Maintenance Schedule to
determine what kind of transaxle fluid to
use. See "Recommended Fluids and
Lubricants" in the Index.
[f the fluid level is low, add only enough
of the proper fluid to bring the level into
the cross-hatched area on the dipstick.
1. Pull out the dipstick.
2. Using a long-neck funnel, add enough
fluid at the dipstick hole to bring it to
the proper level. It doesn't take much
fluid, generally less than a pint (OSL).
Don't overfill. We recommend you
use only fluid labeled DEXRON@-111
or DEXRON@-IIE, because fluids
with that label are made especially for
your automatic transaxle. Damage
caused by fluid other than
DEXRON@-111 or DEXRON@-IIE is
not covered by your new vehicle
warranty.
0
After adding fluid, recheck the
fluid level as described under
"How to Check."
When the correct fluid level is
obtained, push the dipstick back in
all the way.
,.
.. ..
.
?!;i
..
!f ;
.
:
.
: , $
t
*
L
..
, , ,
, ,
i
I85