Table of Contents
Advertisement
dXX
Function
d05
Cooling Control
d07
Valve Protection
d08
Frost Setpoint
d09
12/24 Hour Format
Daylight Saving Time
d11
(DST)
Maximum limitation of
d12
heating setpoint
Minimum limitation of
d13
cooling setpoint
Floor sensor protection limit
d14*
(heating high limit-HL)
Floor sensor protection limit
d15*
(heating low limit-LL)
Floor sensor protection limit
d16*
(cooling)
d17
Preset program selection
d18
Heat/Cool Mode Selection
d19**
Cooling Blocked
Actuators loading selection
d20
for different temperature
compensation.
*Parameters d14, d15, d16 will be available only if parameter d04 is active (d04=1).
**Cooling Blocked - at „1" we block cooling for a single room until the device receives a heating command. During the blocking of the cooling function
no message is displayed.
**Please note!
d19 parameter will be available only if d18 is set on 1.
26
Parameter
Values
1
2
Valve protection function is intended to protect thermostatic valves against
1
getting stuck or jamming (e.g. in summer time when heating system is disa-
bled). If thermostat doesn't send a signal for heating for a period of 7 days, then
heating is turned on for a very short period of time just to move the actuators.
In Frost protection mode the thermostat is displaying actual room tem-
perature and maintain „frost protection" setpoint temperature specified
5°C - 17°C
in thermostat settings. When thermostat works in Frost protection
mode then you have no possibilities to change temperature setpoint.
0
1
0
1
This parameter allows to limit temperature setpoint range by setting
5°C - 35°C
maximum setpoint for heating and cooling modes. Default temperature
This parameter allows to limit temperature setpoint range by setting
5°C - 40°C
minimum setpoint for heating and cooling modes. Default temperature
Turn off relay output when floor sensing temp >
11°C - 45°C
Turn on relay output when floor sensing temp <
6°C - 40°C
Turn off relay output when floor sensing temp <
6°C - 45°C
Select one of these 5 default programs. Once selected, default program will
1-5
overwrite present program. Selected default program can be edited by the
0
1
0
1
1
2
3
4
5
Description
SPAN ± 0.25°C (± 0.5°F)
SPAN ± 0.5°C (± 1.0°F)
Enable.
12hours
24hours
Off
On
setting range: 5⁰C - 35⁰C
setting range: 5⁰C - 40⁰C
protecting limit, step is 0.5°C
protecting limit, step is 0.5°C
protecting limit, step is 0.5ºC
user in the User Setting Mode.
No connection
Connection
Cooling disabled
Cooling allowed
x1 actuator loading
x2 actuators loading
x3 actuators loading
x4 actuators loading
x5 actuators loading
Default
Values
2
1
5.0°C
1
1
35°C
5°C
27°C
10°C
6°C
1
0
0
1
Advertisement
Table of Contents
