Maintaining Your "Benza" Machine; Replacing The Belts - benza ER73AV2TE Information For Users

MAINTAINING THE MACHINE
ELT REPLACEMENT
This machine has a total of 3 belts: 2 rotavator belts and 1 traction belt
FIG. 13
FIG. 14
Engine
pulley
Engine
pulley
clamping
screw
In order to replace the belts, first remove the belt cover, releasing the three screws. (fig. 13)
Then, take out the engine pulley by removing the central clamping screw (fig. 14)
Replace the old belts with new ones, placing them in the pulley grooves and replacing the pulley in the engine
shaft. Replace the pulley screw. Remember that when removing the engine pulley, there is a pin inside which
must be replaced if it has come out of its slot.
Take care to place the belts inside their guides and the chain tensioner, as shown in fig. 14.
Then place the belt cover and the clamping screws into position.
I
38
Information for users
Belt cover
Belt cover
screws
Belt guides
Traction belt
tensioner
Rotavator chain
tensioner
Belt housing
Rotavator belts
Traction
Belt