Table of Contents
Advertisement
Start a Programme
1. Open the door and Press the ON/OFF button
*The display will show the wash programme time
2.Press
to select the program you want on the dishwasher control panel.
3. Press
to start the programme and close the door.
NOTICE
If the MEMO MODE YES The appliance remembers the last programme
you used. The next time the appliance will switch on, the appliance pre-selects
the programme last used.
Pause and restart a wash programme
1. Open the door carefaly to pause the programme.The time remaining will flash
and the pause beep will sound while the dishwasher is paused.
NOTICE
There is a risk of being sprayed with hot water,do not fully open the door until
the spray arms have stopped rotating.
2.Load,remove,or rearrange any dishes if needed.
3.Close the door to restart the programme.
Cancel or change a wash programme
Open the door carefully to pause the programme.Press and hold
Washing program reset.And then you can choice a new wash programme to start.
Start a Programme with Delay
Set a start time by the following procedure
1.Set a programme.
●
2.Press and hold the reservation button
delay time (from 1 to 23 hours).
*The LED molds delay time is 3h,6h,9h.
3.Press the START/PAUSE button
The display shows the countdown of the start delay. The countdown decreases
with steps of 1 hour.
When the countdown is completed, the programme starts.
●
●
to turn the dishwasher on.
in order to delay a programme start:
until the display flashes the required
and close the door.
●
Daily Use
3 sec.
29
Advertisement
Table of Contents
