Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Hoover H-DISH 500 HF 6C2F0PX-80
Summary of Contents for Hoover H-DISH 500 HF 6C2F0PX-80
-
Page 2: Table Of Contents
Thank you for choosing this product. Contents We are proud to offer the ideal product for you and the best complete range of home 1. GENERAL SAFETY RULES appliances for your daily routine. 2. WATER CONNECTION Carefully read this manual for correct and safe appliance use and for helpful tips on 3. -
Page 3: General Safety Rules
1. GENERAL SAFETY sensorial or mental capacities, without experience or knowledge RULES of the product, only if supervised This appliances is intended to or provided with instruction as be used in household and to the operation of the appliance, similar applications such as: in a safe way with awareness −... - Page 4 The manufacturer declines all Water pressure must between 0.08 MPa and 1 MPa. responsibility for any damage to people or property due to Make sure carpets or rugs do non-earthing of the machine. not obstruct the base or any of the ventilation openings.
- Page 5 Do not leave the appliance If you need to move the exposed to the elements (rain, machine after removing the sun, etc.). packaging, do not try to lift it by the bottom of the door. Open Leaning or sitting on the open ...
- Page 6 Follow the instructions supplied with the product. WARNING: Ensure that product, before being switched on for WARNING: the first time, is installed in a horizontal position by way of (only built-in semi- the adjustable feet. integrated models) Check the horizontal position Do not connect the dishwasher using a spirit level to the mains supply until all...
-
Page 7: Water Connection
2. WATER CONNECTION If the dishwasher is connected to new The appliance must be connected to pipes or to pipes which have not been the water mains using new hose-sets. inuse for a long time run water through for The old hose-sets should not be a few minutes before connecting the inlet reused. - Page 8 AQUASTOP (fig.4): Hydraulic safety devices A device located on the supply tube that stops water flow if the tube deteriorates; in this case, a red mark will appear in the All the dishwashers are equipped with window "B" and the tube must be an overflow safety device which, if replaced.
- Page 9 Connecting the outlet hose The outlet hose should disharge into a The hose can be hooked over the side of standpipe, making sure that there are no the sink, but it must not be immersed in kinks (fig.5). water, in order to prevent water from being syphoned back to the machine The standpipe must be at least 40 cm...
-
Page 10: Loading The Salt
3. LOADING THE SALT (Fig. A "1") The appearance of white stains on dishes is generally a warning sign that the salt container needs filling. On the bottom of the machine there is a container for the salt for regenerating the softener. -
Page 11: Adjusting The Upper Basket (Only On Some Models)
4. ADJUSTING THE UPPER To lift it: lift the basket holding it by the sides, as soon as it is in a raised position, BASKET (ONLY ON SOME let it go without applying any pressure to the MODELS) levers. Type "A": 1. -
Page 12: Loading Dishes
5. LOADING DISHES Position the larger plates, slightly inclined towards the front in order to facilitate the easy insertion of the basket inside the Using the upper basket machine. Cup Holder (only on some models) WARNING: The upper basket (fig. 1) is equipped with movable supports hooked to the side panel. - Page 13 "TOTAL CARE+" (only on some models) Hoover H-Dish is equipped with Total Care+, a Specific set of accessories for taking care of the most precious and delicate items like crystals, pottery, wine glasses and more: Dedicated double support (left & right)
- Page 14 An example of the positioning of the Cutlery rack is shown in figure 9. WARNING: Knives and other utensils with sharp points must be loaded in the basket with their points facing down or placed in a horizontal position. The rational and correct arrangement of the dishes is an essential condition for a good USING THE THIRD BASKET washing result.
-
Page 15: Information For Test Laboratories
6. INFORMATION FOR TEST LABORATORIES Please information required comparison testing and measuring noise levels, according to EN normative, to the following address: testinfo-dishwasher@candy.it In the request, please specify model name and number of the dishwasher (see rating plate). POWER WASH (only on some models) some programmes... -
Page 16: Loading The Detergent
7. LOADING THE DETERGENT (Fig. A "2") The detergent It is essential to use a detergent that is specifically designed for dishwashers If you are using tablets, one should suffice. either in powder, liquid,gel or tablet form. Insert the TABLETS, making sure that they do not interfere with the opening system. - Page 17 Loading pre-wash detergent in programmes that require it In programmes that have a pre-wash cycle that requires additional dose detergent (see the washing programmes chapter), the additional detergent must be poured into the appropriate location (C).
-
Page 18: Types Of Detergent
8. TYPES OF DETERGENT read carefully and follow the manufacturer’s instructions given on the packaging; Detergent tablets the effectiveness of detergents containing the built in water softener/salt depends on Detergent tablets of different manufacturers the hardness of your water supply. Check dissolve at different speeds, for this reason, that the hardness of your water supply is during short programmes, some detergent... -
Page 19: Loading The Rinse Aid
9. LOADING THE RINSE AID The lid clicks into the locking position. (Fig. A "3") Always use rinse additives that are suitable for automatic dishwashers. Rinse aid Models equipped with display or rinse aid indicator (only on some Rinse aid, which is automatically released models) during the last rinsing cycle, helps the dishes to dry quickly and prevents spots... - Page 20 limestone content water limestone content water considerably affects formation considerably affects formation limescale and the drying performance. limescale and the drying performance. It is therefore important to regulate the It is therefore important to regulate the quantity of rinse aid to achieve good quantity of rinse aid to achieve good washing results.
-
Page 21: Cleaning The Filters
10. CLEANING THE FILTERS Remove the gauze filter (fig.3) and wash the whole unit under a jet of water (fig.4). (Fig. A "4") If necessary a small brush can be used. The filter system consists of: - A central container that traps the larger particles;... - Page 22 WARNING After cleaning the filters, make sure that they are correctly reassembled and that the gauze filter is properly positioned at the bottom of the dishwasher. Make sure that the filter is screwed back, clockwise, into the gauze, as poor seating of the filter unit could have an adverse effect on the efficiency of the appliance.
-
Page 23: Practical Hints
11. PRACTICAL HINTS Achieve the best use of energy, water, detergent time using recommended maximum load size. Save How to get really good wash up to 50% energy by washing a full load results. instead of 2 half loads. Before placing dishes... - Page 24 It is a good idea not to put silver cutlery Useful hints with non-stainless steel handles into the dishwasher as there could be a chemical In order to avoid any dripping from the top reaction between them. rack, remove the lower rack first. If the dishes are to be left in the machine ...
-
Page 25: Cleaning And Maintenance
12. CLEANING AND MAINTENANCE Looking after your appliance correctly can extend its lifespan. Cleaning the appliance’s exterior Disconnect the machine from the power supply. 2) The lower rotor arm can be extracted by To clean the dishwasher outside, do not ... - Page 26 4) when you have finished, refit the rotor WHEN CYCLE IS FINISHED. arms same position, remembering to re-align the arrow and After every wash it is essential to turn off screw into position (fig.4). water supply and to switch off the machine by pressing the On/Off button to the off position.
-
Page 27: Description Of The Control
13. DESCRIPTION OF THE 14. TECHNICAL DATA CONTROL PANEL... -
Page 28: Programme Selection And Special Features
15. PROGRAMME SELECTION Next time you switch on the AND SPECIAL FEATURES appliance ON/OFF button Hold down the ON/OFF button to turn the machine on and the "ECO" programme, or To turn the appliance on and off, press the programme you have decided to use, the ON/OFF button. - Page 29 5. At this point it will be possible to set a The "intermittent" working of the washing new programme using the "PROGRAMME pump is NOT to be considered a SELECTION" keys. malfunction; it is a characteristic of impulse washing, therefore should be considered a normal feature of the programme.
- Page 30 LANGUAGE SETTING HALF LOAD/SETTING button 1. Switch on the dishwasher with the "ON/OFF" button. This key allows you to select two different functions: 2. Keep the "OPTIONS" button pressed for about 5 sec. "HALF LOAD" 3. The "SETTINGS" message appears on "HALF LOAD"...
- Page 31 BUZZER INDICATOR SELECTIONS AND This option is recommended when SETTINGS using the RAPID programme, whose The buzzer signal that sounds upon duration will be extended to enable pressing the keys used for selecting and improved performance setting washing functions and options can detergent tablets.
- Page 32 MEMO FUNCTION After a period of 5 min. the dishwasher goes into stand-by by turning off the lights. To enable storage of the last programme used, proceed as follows: After the end of the cycle, to use the internal lighting again, press the ON/OFF 1.
- Page 33 FLOOR LIGHT the cycle temperatures increase to over (only in models where present) 65° C, starting a powerful sanitizing treatment, applied to the baskets and the main plastic components inside While the washing program is running, a dishwasher. floor light is projected onto the floor under the dishwasher door.
- Page 34 "AUTO DOOR" button WARNING: (only on some models) Do not insert objects into the slots of the DRY BOOST protection grid, to This option activates a special device that avoid damaging the product. opens the door a few centimetres during or at the end of the drying cycle (depending on the programmes), favouring a more natural and efficient drying of the dishes.
- Page 35 3. The display will show "CHILD LOCK DELAY START button ON" and a short beep will be heard. Delay start selection 4. Only the "ON/OFF" button will This button allows you to programme the remain active. start of the wash cycle, with a delay between 0:30 and 24 hours.
- Page 36 1. To start the DEMO MODE, press the the countdown of the delay time starts showing on the display "START IN XX: XX". "ON/OFF" and "HALF LOAD/ The time will be displayed with an interval SETTINGS" buttons simultaneously of every 30 minutes in the 24 hours, and for 10 seconds.
-
Page 37: Remote Control (Wi-Fi)
16. REMOTE CONTROL (WI-FI) Successful pairing If pairing with the App is successful, the This appliance is equipped with Wi-Fi "Wi-Fi" light will be on steady. technology that allows the machine to be remote controlled via an app. The display will show "CONNECTED", ... - Page 38 Close the door. Opening door, REMOTE CONTROL will be disabled. To resume For built-in models, do this before control from the App, close the door. turning the appliance on. You can now control the dishwasher from the App. Wi-Fi connection indicator light Indicates the connection status of the DISABLING REMOTE CONTROL...
-
Page 39: Programme Legend
17. PROGRAMME LEGEND Programme Description A programme that automatically selects the most efficient and effective duration and temperature of AUTO CARE the cycle depending on the load and degree of grime* *Only on certain models. A gentle cleaning cycle for your most precious delicate dishes crystals. - Page 40 Functions And Options Programme AUTO CARE YES* ● GLASS CARE YES* YES* UNIVERSAL YES* ● INTENSIVE YES* RAPID 49’ YES* 59MIN YES* PREWASH YES*...
- Page 41 ● = Add detergent for prewash ¹ = only on some models ² = Only if function is activated via SETTINGS. "HALF LOAD/HALF LOAD PRO" option available depending on the model N/A= OPTION NOT AVAILABLE ³ = With cold water (15°C) – Tollerance ±10% With hot water the time remaining until the end of the programme is automatically displayed while the programme is running.
-
Page 42: Water Softener Unit
18. WATER SOFTENER UNIT Depending on the source of the supply, Regulate the setting of your water softener water contains varying amounts unit according to the degree of hardness of limestone and minerals which are deposited your water, as follows: on the dishes leaving whitish stains and marks. - Page 43 For the Eco cycle, it is as shown in the table. WARNING! If you cannot complete the procedure, Level DISPLAY Frequency turn the dishwasher off by pressing the "ON/OFF" button and start the procedure again from the beginning DISPLAY S0 Never (STEP 1).
-
Page 44: Troubleshooting And Warranty
19. TROUBLESHOOTING AND WARRANTY If you believe the dishwasher is not working correctly, consult the quick guide provided below with some practical tips on how to fix the most common problems. If the malfunction continues or recurs, contact the Technical Assistance Centre. BUG REPORTS Models with a display: errors are reported by a number preceded by the letter "E"... - Page 45 Uncontrolled water supply with open solenoid valve. ERROR (with display) with a short Close the water tap immediately and disconnect the appliance from audio signal the power supply. Turn off and unplug the dishwasher, wait a minute. Turn on the Any other code machine and restart a program.
- Page 46 CAUSE SOLUTION FAULTS Filter is dirty Clean filter Drain pipe is bent Eliminate the bends in the pipe 3. Dishwasher The drain pipe extension is not Follow the instructions for connecting does not correctly connected the drain pipe carefully discharge water The outlet connection on the wall is pointing downwards not Call a qualified technician...
- Page 47 FAULTS CAUSE SOLUTION Check salt and rinse aid level and 9. Presence of regulate. Should the fault persist, white spots on Mains water is too hard contact the Technical Assistance dishes Centre The dishes knock against one Re-check loading of dishes in the another basket 10.
- Page 48 Assistance and Warranty The product is guaranteed under the law, and under the terms and conditions stated on the warranty certificate included with the product. The certificate should be stored and shown to an authorized Technical Assistance Centre in case of need, together with the proof of purchase. You can also check the warranty conditions on our website.
-
Page 49: Environmental Conditions
20. ENVIRONMENTAL CONDITIONS This appliance marked WEEE should treated cording to the European directive household waste; 2012/19/EUon Waste Electrical Electronic Equipment WEEE should be handed over to the (WEEE). relevant collection points managed by WEEE contains both polluting substances municipality registered (which can cause negative consequences... - Page 52 - HF 5C7F0W-80 -...